The Stealth-Pod’s smaller size leaves much of your cargo space intact and the portability is great for times when all cargo space is needed! The Stealth-Pod lives up to its name, the 10” subwoofer is unseen by passers-by and the pod can’t be removed (in most models) unless you open the tailgate or flip down the back seat. The Stealth-Pod has Fiber-Fill inside and produces truly remarkable sound; the subwoofer fires downward on an angle, maximizing bass output and providing the low-end audio void your Jeep’s probably missing. The speaker is protected from view, damaging cargo, and the elements. Talk about versatility…at the base of the pod are little rubber feet so you can take it indoors, put it on the floor, and use it in your home stereo system!
The Stealth-Pod should be powered by a 2-channel bridgeable amplifier. Install your amplifier in a secure, unseen place, such as under one of the seats, and run the speaker wires under the carpet and up to the pod, into the special plug. (Just leave about a foot of slack in the wire so you can open the tailgate with the pod suspended on the gate.) When you want to remove the pod from your Jeep, just open the tailgate, pull the speaker wire plug (it pops right out of the spring-loaded terminal), then lift the pod off the custom hangers by its handle. At this point the electrical connection is no longer made- your amplifier is still “on” but is sitting idle and the rest of your existing audio system works as it always did. No need to unplug or turn off the amplifier, just unplug the Stealth-Pod, that’s it! The tiny 1” hangers installed on the tailgate are all that remain.
The Stealth-Pod is a .70 cu/ft. sealed enclosure made of very strong, no-flex ¼” textured plastic that houses just about any 10” subwoofer, even subwoofers with very large magnets. All Stealth-Pods come with a 10” foam speaker gasket for an air-tight seal. The Stealth-Pod is loaded with a 10” Legacy® subwoofer rated at 500 watts rms and a bridgeable Legacy® 400 watt amplifier along with an 8-gauge amplifier wiring kit. Installation hardware and detailed instructions with photos are included with every Stealth-Pod.